All our decals are made with the highest quality Oracal outdoor vinyl and come with full application instructions. Toyota Off Road Decals Custom designed Toyota off road decals hand made in house at Pathmaker Productions.We have 14 different colors of vinyl currently in stock and multiple sizes of each design to choose from! Funny 4x4 Decals Custom designed off road decals hand made in house at Pathmaker Productions.Outdoor Adventure Nature Decals Custom designed outdoor adventure decals hand made in house at Pathmaker Productions. Vinyl Decals Custom designed off road decals hand made in house at Pathmaker Productions.To clear the ECU of any stored codes turn the switch to the “DIAGNOSTICS” position and then back to the “ON” position and turn off the key.ġ986.5-1995 Nissan ODB1 ECU Flash Codes for all engines:.Example: Seven red flashes and six green flashes means code 76: Fuel Injection System Function Right Hand Side. Note each code as it is displayed, the red LED flashing for 10’s column, and the green LED flashing for for 1’s column. After about five seconds it will start to blink the diagnostic codes on the ECU. Typically if you want to pull the codes you’re looking for mode 3 so wait until the LEDs blink 3 times move the toggle switch back to the On position. The LED’s on the ECU begin blinking the modes as I explained above. The check engine light will turn off, wait 5 seconds, then turn the screw all the way back counter clockwise. VG30E: Turn the ‘diagnostic mode selector’ screw on the side of the ECU all the way clockwise.Mode 3 is typically the place to start as it will give you the error codes stored in the ECU and you can check them in the chart below. One blink, pause, two blinks, pause, three blinks, pause…etc for each of the 5 modes. The red and green LED’s on top of the ECU will start blinking. Using a small flathead screwdriver, flip it to the diagnostics position. Remove the tab and behind it you will find a small toggle switch with 2 positions, “ON” and “DIAGNOSTICS”. VG30i: There is a little plastic tab holding the switch on the ECU.Turn ignition switch on, but don’t start the engine.The ECU will save codes and the check engine light will remain on. To save the stored codes, simply turn the key off while the check engine light is flashing.To clear all the stored codes and turn the check engine light off, turn the screw all the way clockwise while in diagnostic mode, wait 5 seconds, then turn the screw back all the way counter clockwise.(The amount of long flashes is the 1st digit, the of short flashes is the 2nd digit) The Check Engine light on the dash will begin to flash the trouble code.Wait 5 seconds, then turn the screw all the way back counter clockwise. Twist the ‘Diagnostic Mode Selector’ screw on the ECU all the way clockwise.Turn ignition switch to on, but don’t start the engine.Test Procedure For the Z24i and KA24E 4-cylinder engines:
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |